 |
CC8-BLUES - Multi-Processing CPU
|
 |
CC8-BLUES - Block Diagram
|
|
Feature Summary CC8-BLUES
|
|
Form Factor
|
Single size CompactPCI style Eurocard (160x100mm2),
front panel width 4HP (20.3mm)
|
|
Processor
|
Support for Intel® CeleronTM and
Pentium®-III (0.18µ Coppermine series) processors, 370-pin
PPGA or FC-PGA package
|
|
Chipset
|
i810 or i810E chip set consisting of:
-
82810 Graphics/Memory Controller Hub (GMCH)
-
82801 I/O Controller Hub (ICH0)
-
82802 Firmware Hub (FWH)
|
|
Memory
|
-
144-pin dual in-line memory module (SO-DIMM) socket, max. module height 1.1inch (28mm)
-
Support for up to 256MB, non ECC, unbuffered synchronous DRAM (SDRAM)
-
Support for serial presence detect (SPD) and non-SPD SO-DIMMs, PC-100 style
|
|
Video Output
|
Analog monitor output (front panel), up to 1280x1024 pixel 16M colours 85Hz refresh rate,
HarLink connector (front panel, HarLink to VGA adapter cable available)
|
|
USB I/O
|
Single type A connector (front panel), USB1.1, data transfer rate of up to 12Mbit/s,
short-circuit protected by electronic power switch, nominal maximum current 0.5A
|
|
Ethernet I/O
|
100Base-Tx/10Base-T Fast-Ethernet controller, RJ45 connector (front panel), 100Mbps
full-duplex, auto-negotiation
|
|
IEEE 1394 FireWire
|
Integrated 1394a-2000 OHCI PHY/Link-Layer Controller, dual ports, 6-position receptacles
(front panel), 400Mbps data transfer rate, remote power distribution,
short-circuit protected by electronic regulator, nominal maximum current 0.5A
|
|
Legacy I/O
|
LPC Super-I/O interface connector, CC6-ACID companion board with Super-I/O controller
available
|
|
IDE/ATA
|
CompactFlash type II socket for CF ATA Flash cards and CF ATA Microdrives (Secondary
IDE)
|
|
CompactPCI
|
32/64-bit, 33.3MHz, non-transparent PCI bridge 133/266MB/s
|
|
Hot Swap Function
|
Board installing and removing without adversely effecting a running system,
"Full Hot Swap" implementation according to CompactPCI Hot Swap Specification
PICMG® 2.1
|
|
BIOS
|
General Software BIOS for embedded systems, 2..8Mbit Flash memory (Firmware Hub)
|
subject to change
CC8-BLUES - Component Assembly Drawing
|
Typical Multi-Processing System with CC8-BLUES CPU Slave Boards
|
Cluster System with CC8-BLUES designed by Digital Vox
|
|
Ordering Information |
|
Alias
|
Ordering No.
|
Short Description
|
|
BLUES
|
CC8-1-BLUES
|
CPCI 3U, FC-PGA 370 Hot Swap Multi-Processing Slave CPU, Celeron 733MHz, i810(E),
USB, 100Mbps Ethernet, dual IEEE 1394 OHCI,
SDRAM 64MB, CompactFlash ATA slot, local expansion I/F, width 4HP
|
|
BLUES
|
CC8-2-BLUES
|
Similar to CC8-1-BLUES, Pentium III 850MHz processor
|
|
BLUES
|
CC8-4-BLUES
|
Similar to CC8-1-BLUES, Pentium III 1GHz processor
|
|
|
CC5-8-RAVE
|
128MB SDRAM option (instead of 64MB provided with the basic version
of the CC8-BLUES), additional charge
|
|
|
CC5-9-RAVE
|
256MB SDRAM option (instead of 64MB provided with the basic version
of the CC8-BLUES), additional charge
|
|
ACID
|
CC6-1-ACID
|
3U Super-I/O module, local expansion board complementing the CC8-BLUES,
front panel 8HP, mounting on top of the CC8-BLUES
|
|
ACID
|
CC6-3-ACID
|
Similar to the CC6-1-ACID, front panel 4HP, w/o parallel port,
mouse/keyboard combined in one Mini-DIN connector (external splitter
cable available as accessory), mounting on top or to the bottom side
of the CC8-BLUES
|
|
|
CR9-1-ADAPT
|
Mechanical kit, expands front panel of the
CC8-BLUES to 6U full height
|
|
|
250.0205.30.03
|
VGA adapter cable 0.5m, video cable assembly for CC8-BLUES, metric I/O
connector to HD-SUB15 female connector
|
|
|
280.7.400
|
Keyboard/mouse splitter cable, male mini-DIN plug to dual female
mini-DIN jacks (required for CC6-3 only)
|
|
